Bit Switches
D432/D433 68 SM
“Subject” address are printed as header information.
When a mail with only binary data is received (a TIFF-F file, for example), this
setting is ignored and no header is printed.
Output from Attached Document at E-mail TX Error
1
This setting determines whether only the first page or all pages of an e-mail
attachment are printed at the sending station when a transmission error occurs.
This allows the customer to see which documents have not reached their intended
destinations if sent to the wrong e-mail addresses, for example.
0: Prints 1st page only.
1: Prints all pages.
Text String for Return Receipt
This setting determines the text string output for the Return Receipt that confirms
the transmission was received normally at the destination.
2-3
00: “Dispatched”
Sends from PC mail a request for a Return Receipt. Receives the Return Receipt
with “dispatched” in the 2nd part:
Disposition: Automatic-action/MDN-send automatically; dispatched
The “dispatched” string is included in the Subject string.
01: “Displayed”
Sends from PC mail a request for a Return Receipt. Receives the Return Receipt
with “displayed” in the 2nd part:
Disposition: Automatic-action/MDN-send automatically; displayed
The “displayed” string is included in the Subject string.
10: Reserved
11: Reserved
A mail requesting a Return Receipt sent from an IFAX with this switch set to “00”
(for “dispatched”) received by Microsoft Outlook 2000 may cause an error. If any
setting other than “displayed” (01) causes a problem, change the setting to “01” to
enable normal sending of the Return Receipt.
Media accept feature
4
This setting adds or does not add the media accept feature to the answer mail to
confirm a reception.
To Next Page
Loading...
Need help?
General
