Ricoh Aficio MP C2550 Service Manual

Process Control Error Conditions
D037/D038/D040/D041 5-2 SM Appendix
No. Result Description Possible Causes/Action
Vcnt is less than 4.7V
when Vcnt is Vt target
±0.2V.
2. Defective TD sensor
9 Vcnt error 3 Vcnt is less than 4.7V.
1. Make sure that the heat seal on the
development unit is not removed
2. Defective TD sensor
3. Vt target settings are not correct.
4. Toner density error
 The machine starts developer initialization after you set “1” in SP3-902-005, 006,
007, or 008. Developer initialization automatically resumes when you open and
close the front door or turn the main switch off and on if an error other than Error 8
occurs.
5.1.2 PROCESS CONTROL SELF-CHECK RESULT
Displayed number shows results of each color sensor check.
00000000 = YYCCMMKK
SP3-012-001 to -010 (Process Control Self-check Result)
No. Result Description Possible Causes/Action
11
Successfully
completed
Process control
self-check
successfully
completed.
Check the Vsg adjustment. See the "Vsg
Adjustment Result" following this table.
41 Vt error
Vt maximum or
minimum error is
detected.
 Defective development unit
Vt maximum error and an image is faint:
1. Replace the toner hopper unit.
Vt maximum error and an image is O.K:
1. Replace the development unit.
2. Replace the BCU board.
Vt minimum error:

Ricoh Aficio MP C2550 Specifications

General

Print Technology	Laser
Functions	Print, Copy, Scan, Fax
Print Speed (Color)	25 ppm
Print Speed (Monochrome)	25 ppm
Print Resolution	600 x 600 dpi
Maximum Print Resolution	2400 x 600 dpi
Duplex Printing	Yes
Copy Speed (Color)	25 cpm
Copy Speed (Monochrome)	25 cpm
Copy Resolution	600 x 600 dpi
Memory (Maximum)	1 GB
Hard Disk Drive (Optional)	80 GB
Interface	USB 2.0, Ethernet 10/100Base-TX
Fax Transmission Speed	33.6 Kbps
Maximum Paper Size	A3
Scan Resolution	600 dpi
Zoom Range	25% - 400%
Paper Size	A4, A5, B5
Paper Weight	52 - 256 g/m²
PDL	PCL 6, PostScript 3
Network Connectivity	Ethernet
Operating System Compatibility	Windows, Mac OS