Installing Options
20
2
H When replacing the default SDRAM module, press down the levers on
both sides ( ) to remove the default module ( ).
Install a new SDRAM module.
To increase memory capacity to the maximum of 512 MB, remove the default
SDRAM module, and then install two 256 MB SDRAM modules.
I To install other options on the controller board, follow the appropriate in-
stallation procedure(s), and then screw down the controller board cover.
J Fasten the four screws to attach the cover.
K Align the controller board with the left and right rails, and then push it
carefully in, until it stops.
The printer may malfunction if the controller board is not properly installed.
AET078S
AQC700S
AQC710S
To Next Page
Loading...
