Ethernet Configuration
69
4
Making Network Settings for Using Netware
If you use NetWare, select the frame type for NetWare.
Select one of the items below if necessary.
•Auto Select
• Ethernet II
• Ethernet 802.2
• Ethernet 802.3
• Ethernet SNAP
Important
❒ Usually, use the default setting ([Auto Select]). When you first select [Auto Se-
lect], the frame type detected by the printer is adopted. If your network can
use more than two frame types, the printer may fail to select the correct frame
type if [Auto Select] is selected. In this case, select the appropriate frame type.
A Press the {Menu} key.
B Select [Host Interface] using {T} or {U}, and then press the {OK} key.
C Select [Network] using {T} or {U}, and then press the {OK} key.
AQC001S
YMCK
To Next Page
Loading...
