Ricoh C2000

Code Meaning Suggested Cause/Action
0-14
Non-standard post message
response code received
• Incompatible or defective remote terminal; try sending
to another machine.
• Noisy line: resend.
• Try adjusting the tx level and/or cable equalizer
settings.
• Replace the NCU or FCU.
Cross reference
See error code 0-08.
0-15
The other terminal is not
capable of specific functions.
The other terminal is not capable of accepting the following
functions, or the other terminal’s memory is full.
• Confidential rx
• Transfer function
• SEP/SUB/PWD/SID
0-16
CFR or FTT not detected after
modem training in confidential
or transfer mode
• Check the line connection.
• Replace the NCU or FCU.
• Try adjusting the tx level and/or cable equalizer
settings.
• The other end may have disconnected, or it may be
defective; try calling another machine.
• If the rx signal level is too low, there may be a line
problem.
Cross reference
See error code 0-08.
0-20
Facsimile data not received
within 6 s of retraining
• Check the line connection.
• Replace the NCU or FCU.
• Check for line problems.
• Try calling another fax machine.
• Try adjusting the reconstruction time for the first line
and/or rx cable equalizer setting.
Cross reference
Reconstruction time - G3 Switch 0A, bit 6
Rx cable equalizer - G3 Switch 07 (PSTN)
Error Codes
19
3