0
TTI printing position
0: Superimposed on the page data
1: Printed before the data leading
edge
Change this bit to 1 if the TTI overprints information that the
customer considers to be important (G3 transmissions).
1 Not used Japan Only
2-7 Not used Do not change the factory settings.
System Switch 12 [SP No. 1-101-019]
No FUNCTION COMMENTS
0-7
TTI printing position in the main scan
direction
TTI: 08 to 92 (BCD) mm
Input even numbers only.
This setting determines the print start position for the TTI from
the left edge of the paper. If the TTI is moved too far to the
right, it may overwrite the file number which is on the top
right of the page. On an A4 page, if the TTI is moved over
by more than 50 mm, it may overwrite the page number.
System Switch 13 - Not used (do not change these settings)
System Switch 14 - Not used (do not change these settings)
System Switch 15 [SP No. 1-101-022]
No FUNCTION COMMENTS
0 Not used Do not change the settings.
1
Going into the Energy Saver mode
automatically
0: Enabled
1: Disabled
1: The machine will restart from the Energy Saver mode
quickly, because the +5V power supply is active even in the
Energy Saver mode.
2-3 Not used Do not change these settings.
4-5
Interval for preventing the machine
from entering Energy Saver mode if
there is a pending transmission file.
Bit 5: 0, Bit 4: 0
If there is a file waiting for transmission, the machine does
not go to Energy Saver mode during the selected period.
After transmitting the file, if there is no file waiting for
transmission, the machine goes to the Energy Saver mode.
4. Service Tables
56
To Next Page
Loading...
