e.g) these setting combination is not allowed:
[Bit1: 0, Bit 0: 0 = Text] [Bit3: 0, Bit 2:0 = Text/ Photo] [Bit 6: 0, Bit 5: 0, Bit 4: 0 = Text]
No. FUNCTION COMMENTS
0-1
Image Quality in Text mode
Bit 1: 0, Bit 0: 0 = Text/ Picture
Bit 1: 0, Bit 0: 1 = Text
This setting determines the desirable scanning image
quality when the text mode is selected with the
operation panel.
2-3
Image Quality in Photo mode
Bit 3: 0, Bit 2: 0 = Photo/ Diffusion
Bit 3: 0, Bit 2: 1 = Photo/ Dithering
This setting determines the desirable scanning image
quality when the photo mode is selected with the
operation panel.
4-6
Image Quality in Special Original
mode
This setting determines the desirable scanning image
quality when the special original mode is selected with
the operation panel.
Bit 6 Bit 5 Bit 4 Mode
0 0 0 Text
0 0 1 Text/ Sharp
0 1 0 Text/ Diffusion
0 1 1 Photo/ Dithering
1 0 0 Dropout color
1 0 1 -
7 Not used Do not change these settings.
System Switch 1C - Not used (do not change these settings)
System Switch 1D [SP No. 1-101-030]
No FUNCTION COMMENTS
0
RTI/CSI/CPS code display
0: Enable
1: Disable
0: RTI, CSI, CPS codes are displayed on the top line of the
LCD panel during communication.
1: Codes are switched off (no display)
1 Not used Do not change this setting.
4. Service Tables
58
To Next Page
Loading...
