4
Action when authorized reception is
enabled but authorized RTIs/CSIs
are not yet programmed
0: All fax reception is disabled
1: Faxes can be received if the
sender has an RTI or CSI
If authorized reception is enabled but the user has stored
no acceptable sender RTIs or CSIs, the machine will not be
able to receive any fax messages.
If the customer wishes to receive messages from any sender
that includes an RTI or CSI, and to block messages from
senders that do not include an RTI or CSI, change this bit to
“1”, then enable Authorized Reception.
Otherwise, keep this bit at “0 (default setting)”.
5-7 Not used Do not change the settings
System Switch 1F [SP No. 1-101-032]
No FUNCTION COMMENTS
0 Not used Do not change the settings.
1
Report printout after an original jam
during SAF storage or if the SAF
memory fills up
0: Enabled
1: Disabled
0: When an original jams, or the SAF memory overflows
during scanning, a report will be printed.
Change this bit to “1” if the customer does not want to have
a report in these cases.
Memory tx – Memory storage report
Parallel memory tx – Transmission result report
2 Not used Do not change the settings.
3
Received fax print start timing
(G3 reception)
0: After receiving each page
1: After receiving all pages
0: The machine prints each page immediately after the
machine receives it.
1: The machine prints the complete message after the
machine receives all the pages in the memory.
4-6 Not used Do not change the factory settings.
7
Action when a fax SC has occurred
0: Automatic reset
1: Fax unit stops
0: When the fax unit detects a fax SC code other than
SC1201 and SC1207, the fax unit automatically resets
itself.
1: When the fax unit detects any fax SC code, the fax unit
stops.
Cross Reference
Fax SC codes - See “Troubleshooting”
4. Service Tables
60
To Next Page
Loading...
