0
Paper size selection priority
0: Width
1: Length
0: A paper size that has the same width as the received data
is selected first.
1: A paper size which has enough length to print all the
received lines without reduction is selected first.
1
Paper size selected for printing
A4 width fax data
0: 8.5" x 11" size
1: A4 size
This switch determines which paper size is selected for
printing A4 width fax data, when the machine has both A4
and 8.5" x 11" size paper.
2
Page separation
0: Enabled
1: Disabled
1: If all paper sizes in the machine require page separation
to print a received fax message, the machine does not print
the message (Substitute Reception is used).
After a larger size of paper is set in a cassette, the machine
automatically prints the fax message.
3-4
Printing the sample image on
reports
Bit 4: 0, Bit 3: 0
= The upper half only
Bit 4: 0, Bit 3: 1
= 50% reduction in sub-scan
only
Bit 4: 1, Bit 3: 0
= Same size
Bit 4: 1, Bit 3: 1
= Not used
“Same size” means the sample image is printed at 100%,
even if page separation occurs.
User Parameter Switch 19 (13H) bit 4 must be set to “0” to
enable this switch.
Refer to Detailed Section Descriptions for more on this
feature.
5-6 Not used Do not change the settings.
7
Equalizing the reduction ratio
among separated pages
(Page Separation)
0: Enabled
1: Disabled
0: When page separation has taken place, all the pages are
reduced with the same reduction ratio.
1: Only the last page is reduced to fit the selected paper size
when page separation has taken place. Other pages are
printed without reduction.
Printer Switch 0F [SP No. 1-103-016]
No FUNCTION COMMENTS
Bit Switches
71