5. Extender for the ADF tray
Extend this when placing paper longer than A4 in the input tray for ADF.
6. Exposure glass
Place originals face down here.
7. Cover for the exposure glass
Open this cover to place originals on the exposure glass.
8. Output tray for the ADF
Originals scanned with the ADF are output here.
9. Stop fence for the ADF
Pull out this fence to prevent originals from falling off.
10. Control panel
See page 65 "Guide to the Names and Functions of the Machine's Control Panel".
11. Ventilation holes
Prevent overheating.
12. Cover for installing an offline stapler
Remove when you install the offline stapler.
13. Internal tray
Copied/printed paper and fax messages are delivered here.
14. Front cover open button
Push this button to open the front cover.
15. Lower paper tray
Load paper here.
For details, see page 37 "Guide to Functions of the Machine's External Options (mainly Europe
and Asia)" or page 38 "Guide to Functions of the Machine's External Options (mainly North
America)".
16. Tray 1
Load paper here.
17. Front cover
Open to access the inside of the machine and remove jammed paper.
Open here to replace the print cartridge and the drum unit.
18. Main power switch
To operate the machine, the main power switch must be on. If it is off, turn the switch on.
See page 91 "Turning On/Off the Power".
19. Stop fence
Pull this fence to prevent paper from falling off.
20. Bypass tray
Use to copy or print on thick paper, OHP transparencies, envelopes, and label paper (adhesive labels).
Guide to Names and Functions of Components
13
To Next Page
Loading...
Need help?
General
