9. Press [Auth. Info], and then press [ Next].
10. Press [Specify Other Auth. Info] on the right side of "Folder Authentication".
When [Do not Specify] is selected, the SMB User Name and SMB Password that you have
specified in "Default User Name / Password (Send)" of File Transfer settings are applied.
11. Press [Change] under "Login User Name".
12. Enter the login user name of the destination computer, and then press [OK].
You can enter up to 64 characters (128 bytes) for the user name.
13. Press [Change] under "Login Password".
14. Enter the password of the destination computer, and then press [OK].
You can enter up to 64 characters (128 bytes) for the password.
15. Enter the password again to confirm, and then press [OK].
16. Press [Folder].
Basic Procedure When Using Scan to Folder
151
To Next Page
Loading...
