Ricoh IM430 Series - Page 154

17. Check that [SMB] is selected.
18. Press [Change] or [Browse Network], and then specify the folder.
To specify a folder, you can either enter the path manually or locate the folder by browsing the
network. You can enter a path up to 256 characters (256 bytes).
For details about how to specify the path manually, see page 152 "Locating the SMB folder
manually".
For details about how to specify the path using Browse Network, see page 153 "Locating the
SMB folder using Browse Network".
19. Press [Connection Test] to check the path is set correctly.
20. Press [Exit].
If the connection test fails, check the settings, and then try again.
21. Press [OK].
22. Press [User Tools] (
) on the top right of the screen.
23. Press [Home] ( ) at the bottom of the screen in the center.
Locating the SMB folder manually
1. Press [Change] under "Path".
2. Enter the path where the folder is located.
You can enter a path up to 256 characters (256 bytes).
Enter the path using this format: "\\ServerName\Share- Name\PathName".
For example: if the name of the destination computer is "User", and the folder name is "Share", the
path will be \\User\Share.
5. Scan
152