USING SERVICE PROGRAM MODES 20 February, 2001
5-18
5
Mode Number/Name Function/[Setting]
PM Alarm Mode
1 Interval Sets the base PM interval.
[1 ~ 255 / 60 / 1K copies/step]
The value stored in this SP is used when the value of
SP5-501-2 is “1”.
501*
2On/Off
Enables/disables the PM alarm for the total number of
prints, copies, and faxes.
[0 = No / 1 = Yes]
Memory All Clear801
Resets all software counters and returns all modes and
adjustments to their defaults settings (except for some
settings, such as SP5-811, SP5-907, SP5-916, and SP7-
003 – ☛ 5.1.8 Memory All Clear for a full list).
[0 = No / 1 = Yes]
• After selecting “1”, press the Original Type key and the
! key at the same time to execute the clear. If the clear
is successful, the display shows “Action completed”. If
the clear fails, the display shows “Error!!!”.
• This SP mode should be used only after replacing the
NVRAM or when the copier has malfunctioned due to
damaged NVRAM.
☛
5.1.8 Memory All Clear
Scanner/Printer Free Run802
Starts a free run of both the scanner and the printer.
[0: = No / 1 = Yes]
After selecting “1”, press the OK key or ! key twice to
start the run. Press " to stop the free run.
Input Check803
Displays the signals being received from sensors and
switches.
Press # to exit the program.
☛
5.1.3 Input Check
Output Check804
Turns on electrical components individually for test
purposes.
☛
5.1.4 Output Check
Display Language Group807*
Selects the display language group.
[0 = Standard / 1 = Option 1 / 2 = Option 2]
The actual display language can be selected using User
Tools: [6. Language]
mm/inch Selection809*
Selects whether the display shows values in mm or
inches.
[North Am.: 0 = inch / 1 = mm]
[EU/Asia: 0 = mm / 1 = inch]
To Next Page
Loading...
