USING SERVICE PROGRAM MODES 20 February, 2001
5-22
5
Mode Number/Name Function/[Setting]
Fax Forwarding Mode930
Selects whether the machine will accept changeover to
fax mode following occurrence of an SC error.
[0 = No / 1 = Yes]
When an SC occurs while there are received fax
messages in the SAF memory, change the value to “1”.
Then access facsimile mode. Then forward the incoming
data to another fax machine using the fax mode bit
switches.
Image Rotation940*
Enables/disables image rotation.
[0 = Enabled / 1 = Disabled]
This function is used for both rotate sort and rotate copy.
Duplex Blank Page941*
Selects whether the blank page is made on the front side
or back side when using duplex copy mode.
[0 = Back Side / 1 = Front Side]
APS Mode Setting944*
Enables/disables APS mode as the power-up default.
[0: Disabled / 1 = Enabled]
By-pass LG Size Detection950*
Selects whether the machine can detect LG paper in the
by-pass tray.
[0 = No / 1 = Yes]
If “No” is selected, the machine detects LT instead of LG.
Interleave Count Setting951*
Selects the interleave count used when interleave mode
has been selected from User Tools [2. System Settings]
→
[11. Print Priority].
[1 ~ 20 / 5 / 1 page/step]
This determines what happens if there are jobs of different
types waiting. If the setting is 5 (for example), interleave
mode will print 5 pages of one job, then 5 pages of the
next job, and so on.
By-pass Paper Type Reset952*
Selects the operational default paper type for the by-pass
tray. The machine returns to the value set here at power
up and whenever ! is pressed.
[0 = Thick / 1 = Plain / 2 = Selected]
If the setting is “2”, the paper type selected in the User
Tools will be used.
To Next Page
Loading...
