20 February, 2001 USING SERVICE PROGRAM MODES
5-21
Service
Tables
5
Mode Number/Name Function/[Setting]
NV-RAM Auto Backup909*
Selects whether or not to back up the data written to the
NV-RAM at power off (see conditions below).
[0 = Disabled / 1 = Enabled]
When enabled, this function creates a back up of the data
if it has been 24 hours since the power was turned on or
since the machine last wrote to the NV-RAM. The backup
goes to a special back-up area inside the NVRAM.
APS A4/LT LEF Priority911*
Specifies whether the machine selects 8
1/2
" x 11" LEF
paper for A4 LEF originals (or vice versa for metric-based
machines).
[0 = No / 1 = Yes]
On inch-based models: If this setting is “Yes,” the machine
automatically selects 8
1/2
" x 11" LEF if the APS sensors
detect an A4 LEF original. On metric (mm) based models:
If this setting is “Yes,” the machine automatically selects
A4 LEF if the APS sensors detect an 8
1/2
" x 11" LEF
original.
This SP is ineffective if the machine has been set up to
detect Chinese paper sizes (SP5-955).
UP Mode Data Reset913
Resets the user tool settings.
[0 = No / 1 = Yes]
• Note that the user codes, key operator code, and key
operator printer counter value are not reset.
• After selecting “1”, press the Original Type key and the
OK key (or ' key) at the same time to execute the
reset. If the reset is successful, the display shows
“Action completed.” If the reset fails, the display shows
“Error!!!”
Printer Counter Display914*
Selects whether the printer counter is displayed on the
LCD ([1. Counter] in the user tools) and in the counter list
printout.
[0 = No / 1 = Yes]
To display the printer counter on the LCD, press the Right
cursor key once. To display the total counter, press it
again.
Language UK/TW Priority916*
Selects the default display language.
[0 = UK (Asia version) / 1 = TW (Taiwan version)]
• Asia and Taiwan versions only.
• This setting is not reset by Memory All Clear (SP5-801).
To Next Page
Loading...
