USING SERVICE PROGRAM MODES 20 February, 2001
5-28
7
Mode Number/Name Function/[Setting]
Memory/Version/PN
1 Main P/N Displays the P/N and suffix of the copier firmware.
2 Main version Displays the version of the BiCU board
3 Fax P/N Displays the P/N and suffix of the fax firmware.
4 Printer P/N Displays the P/N and suffix of printer firmware.
5 ADF ROM Displays the P/N and suffix of the ADF ROM.
6 Copier memory Displays the total amount of copier memory installed.
801
7 # optional trays Displays the number of optional paper trays currently
installed.
Display – PM Counter803*
Displays the PM counter value (since the last PM).
Reset – PM Counter804
Resets the PM counter.
[0 = No / 1 = Yes]
After selecting “1”, press the Original Type key and the
OK key (or ' key) at the same time to execute the reset.
If the reset is successful, the display shows “Action
completed.” If the reset fails, the display shows “Error!!!”.
Reset – SC/Jam Counters807
Resets the SC, paper, original, and total jam counter
values.
[0 = No / 1 = Yes]
After selecting “1”, press the Original Type key and the
OK key (or ' key) at the same time to execute the reset.
If the reset is successful, the display shows “Action
completed.” If the reset fails, the display shows “Error!!!”.
Reset – Counters808
Resets all counters except for the total print counters
(SP7-003) and timer counter (SP7-991).
[0 = No / 1 = Yes]
After selecting “1”, press the Original Type key and the
OK key (or ' key) at the same time to execute the reset.
If the reset is successful, the display shows “Action
completed.” If the reset fails, the display shows “Error!!!”.
Reset – Key Operator Code810
Resets the key operator code.
[0 = No / 1=Yes]
• After selecting “1”, press the Original Type key and the
OK key (or ' key) at the same time to execute the
reset. If the reset is successful, the display shows
“Action completed.” If the reset fails, the display shows
“Error!!!”.
• If the customer forgets the key operator code, clear it by
using this SP mode and re-input the code using: [2.
System Settings]
→
[13. Key Operator Tools]
→
[14.
Program Key Operator Code].
To Next Page
Loading...
