Appendix
98
9
❖ Interface domain configuration
The following command displays or sets the Ethernet interface domain name
or IEEE 802.11b interface.
msh> domainname interface_name domain_name
The following is a sample configuration using a domain name on the Ethernet
interface:
msh> domainname ether domain_name
*1
Available when the IEEE 802.11b interface unit is installed.
Note
❒ A domain name can consist of up to 63 alphanumeric characters.
-Setting Protocols
The protocols described in this section provide various functions that can be
used on the printer.
Important
❒ If a protocol is disabled or inactive, functions provided by that protocol can-
not be used.
Reference
For more information about setting protocols, consult your network adminis-
trator.
❖ TCP/IP
• Functions using ftp, lpr, rsh/rcp, diprint, http, ipp, web, wins, or smb
*1
*1
SMB session using TCP/IP
Note
❒ You cannot switch between protocols, but turning off or disabling TCP/IP
will also disable smtp and dns.
❖ AppleTalk
• Printer function using AppleTalk under Macintosh
Note
❒ This can be configured when a module supporting PostScript board is in-
stalled in the printer.
Interface Interface that can be set
ether Ethernet interface
wlan
*1
IEEE 802.11b interface
To Next Page
Loading...
