Appendix
102
9
Error Messages on the Display
This section describes the most common network-related messages that appear
on the display. If a message not described here appears, act according to that
message.
Reference
Before turning the main power off, see “Turning On the Power”, Operating In-
structions.
Message Causes Solutions
Ethernet Error An error has occurred in the
Ethernet module.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
IEEE802.11b Error IEEE 802.11b card was not in-
serted when the printer was
turned on, or it was pulled out
after the printer turned on. An
error has occurred in the IEEE
802.11b card.
Turn off the main power
switch, and check the card is
installed correctly. If the mes-
sage appears again, contact
your sales or service repre-
sentative.
To Next Page
Loading...
