Ricoh Priport HQ9000 - Setting up as a Remote Printer

Using the Printer Function
36
5
Setting Up as a Remote Printer
NetWare 3.x
A Log on to the file server as an administrator, or equivalent.
B Start SmartDeviceMonitor for Admin.
C On the [Group] menu, point to [Search Device], and then click [IPX/SPX].
A list of machines appears.
D In the list, select the printer for which you want to change configuration.
E On the [Tools] menu, click [NIB Setup Tool].
NIB Setup Tool starts.
F Click [Property Sheet], and then click [OK].
The [NIB Setup Tool - Network board list] dialog box appears.
G Click the [NetWare] tab, and then make the following settings:
A In the [Print Server Name:] box, enter the name of the print server.
Limitation
❒ Enter up to 47 alphanumeric characters.
B In the [File Server Name:] box, enter the name of the file server in which a
print server is to be created.
By clicking [Browse...], you can select a file server among those listed in the
[Browse...] dialog box.
Limitation
❒ Enter up to 47 alphanumeric characters.
C In the [Print Server Operation Mode] area, click [As Remote Printer].
D In the [Remote Printer No.] box, enter the printer number.
Important
❒ Use the same printer number as that to be created in the print server.
E Click [OK] to close the [NIB Setup Tool - Network board list] dialog box.
H Quit SmartDeviceMonitor for Admin.
I Enter “PCONSOLE” from the command prompt.
F:> PCONSOLE