Ricoh Priport HQ9000 - Printing with a Mac os; Changing to Ethertalk

Using the Printer Function
28
5
Printing with a Mac OS
This section describes how to configure a Mac OS computer to use EtherTalk.
Actual procedures may vary depending on the version of the Mac OS. The fol-
lowing procedures describe how to configure Mac OS 9.1 and Mac OS X v10.1.
If you are using other version than Mac OS 9.1 and Mac OS X v10.1, see the man-
ual that comes with Mac OS for more information.
Note
❒ Mac OS 8.6 and later versions are supported (except for Mac OS X v10.0.x).
❒ To print from a Mac OS, PostScript board is required.
Changing to EtherTalk
Follow the procedure below to configure a Mac OS computer to use EtherTalk.
Reference
For more information about installing the software required for EtherTalk,
see the Mac OS manuals.
Mac OS
A Open [Control Panel], and then double-click the AppleTalk icon.
B On the [Connect via] pop-up menu, click [Ethernet].
C If you change zones, select a name on the [Current zone] pop-up menu.
D Close the [AppleTalk] control panel.
E Click [Save].
F Restart the Mac OS.