Appendix
80
9
E Enter “yes” to save the changes, and then press the {ENTER} key.
If you do not want to save the changes, enter “no”, and then press the {EN-
TER} key. If you want to make additional changes, enter “return”, and then
press the {ENTER} key.
Note
❒ If “Cannot write NVRAM information” appears, the changes are not
saved. Repeat the steps above, as necessary.
❒ The network interface module is automatically reset when the changes are
saved.
❒ When the network interface module is reset, active print jobs already sent
to the printer will be finished. However, jobs not already sent will be can-
celed.
Commands List
Use the “help” command to display remote maintenance use.
Note
❒ Enter “help” to display a list of commands that can be used.
msh> help
❒ Enter “help command_name” to display information about the syntax of that
command.
msh> help command_name
TCP/IP address
Use the “ifconfig” command to configure the Ethernet interface, IEEE 802.11b in-
terface, and the TCP/IP (IP address, subnet mask, broadcast address, default
gateway address) for the printer.
❖ Reference
msh> ifconfig
To Next Page
Loading...
