Ricoh Priport HQ9000 - Configuring a Windows XP Computer

Windows Configuration
16
4
D Click [Properties].
E Configure TCP/IP using the appropriate IP address, subnet mask, and oth-
er settings.
Check with the network administrator that the settings are correct.
Configuring a Windows XP Computer
Follow the procedure below to configure a Windows XP computer to use
TCP/IP.
A On the [Start] menu, click [Control Panel], and then click [Network and Internet
Connections].
B Click [Network Connections], and then double-click [Local Area Connection].
C On the [General] tab, click [Properties].
D Make sure [Internet Protocol (TCP/IP)] is selected in the [This connection uses the
following items] box on the [General] tab.
Note
❒ Select TCP/IP if it is not already selected.
❒ If TCP/IP is not installed, click [Install] on the [General] tab to install it. For
more information about installing TCP/IP, see Windows XP Help.
E Click [Properties].
F Configure TCP/IP using the appropriate IP address, subnet mask, and oth-
er settings.
Check with the network administrator that the settings are correct.