Remote Maintenance by telnet
79
9
Remote Maintenance by telnet
You can view printer status and configure the network interface module using
telnet.
Note
❒ You should specify a password so only the network administrator, or a per-
son with network administrator privileges, can use remote maintenance.
❒ The password is the same as that used for configuring the network interface
module with a Web Image Monitor.
❒ If you change a password using remote maintenance, the other passwords are
also changed.
Using telnet
Follow the procedure below to use telnet.
Limitation
❒ Only one person at a time can be logged on to do remote maintenance.
A Using the machine's IP address or host name, start telnet.
% telnet IP_address
Note
❒ In order to use the host name instead of the IP address, you must write it
to the hosts file.
B Enter the password.
Note
❒ The default is “password”.
C Enter a command.
Reference
For more information about telnet commands, see p.80 “Commands List”.
D Quit telnet.
msh> logout
When the configuration changes, a message asks whether the changes should
be saved or not.
To Next Page
Loading...
