User Tools Menu (System Settings)
9
3
Network Configuration
Any change you make with User Tools remains in effect even if the main power
switch or operation switch is turned off, or if the {Clear Modes} key is pressed.
Configuring the network using the control panel
Note
❒ Operations for System Settings are different from normal operations. After
using User Tools, press the {User Tools} key to exit.
❒ If the key operator code has been set, the key operator code entry screen ap-
pears. Enter the code, and then press the [OK] key. For details about the key
operator code, see Operating Instructions.
A Press the {User Tools} key.
B Press [System Settings].
C Press [Interface Settings].
D Select the setting you want to change, and then press [OK].
E Change the setting, and then press [OK].
Note
❒ To cancel changes made to settings and return to the System Settings
menu, press [Cancel].
F Press [Exit].
G Press the {User Tools} key.
Note
❒ You can also exit by pressing [Exit] on the User Tools main menu.
AJK135S
To Next Page
Loading...
