Printing with NetWare
35
5
C In the [File Server Name:] box, enter the name of the file server in which
the print server is to be created.
By clicking [Browse...], you can select a file server among those listed in the
[Browse...] dialog box.
Limitation
❒ Enter up to 47 alphanumeric characters.
D In the [NDS Tree:] box, enter the NDS tree name in which to make the file
server.
By clicking [Browse...], you can select the NDS tree name and NDS context
name from their lists.
Limitation
❒ Enter up to 32 alphanumeric characters (“-” and “_” can be used).
E In the [NDS Context:] box, enter the context of the print server.
Limitation
❒ Enter up to 127 alphanumeric characters.
Note
❒ As context, object names are entered in lower object order and divided
by a period. For example, if you want to create a print server into NET
under d, enter “d”.
F In the [Print Server Operation Mode] area, click [As Print Server].
G Click [OK] to close the [NIB Setup Tool - Network board list] dialog box.
I Quit SmartDeviceMonitor for Admin.
After this step, operate the printer by following the procedure from step
I
on
p.38 “NetWare 4.x, 5/5.1, 6”. However, steps
N
-C and
N
-D are not required.
To Next Page
Loading...
