Appendix
66
9
lpr
❖ When specifying a printer by IP address
c:> lpr -Sprinter's IP address [-Poption] [ol] \pass name\file
name
❖ When using a host name instead of an IP address
c:> lpr -Sprinter's host name [-Poption] [ol] \pass name\file
name
Note
❒ When printing a binary file, add the “-ol” option (lowercase o, and lower-
case l).
When using a printer with the host name “host”, to print a PostScript file
named “file1” located in the C:\PRINT directory, the command line is as fol-
lows:
c:> lpr -Shost -Pfiletype=PS3 -ol C:\PRINT\file1
rcp
Register the printer's host name in the hosts file beforehand. See p.64 “Using a
Host Name Instead of an IP Address”.
c:> rcp [-b] \pass name\file name [pass name\file name...]
printer's host name:[option]
Note
❒ In the file names, “*” and “?” can be used as wild cards.
❒ When printing a binary file, add the “-b” option.
When using a printer with the host name “host”, to print a PostScript file named
“file1” or “file2” located in the C:\PRINT directory, the command line is as fol-
lows.
c:> rcp -b \PRINT\file1 \PRINT\file2 host:filetype=RPS
To Next Page
Loading...
