Cutting Media
This section explains how to cut roll media.
Roll up cut media with the roll-up unit so that the printing surface of the media does not touch the floor or
the printing surface of another piece of media.
1. Press [Origin Setting/Cut] on the bottom right of the screen.
2. Press [Cut].
3. Select the position from where to cut media from either [Base line position on the media
guide] or [Position of the cutter].
Select [Base line position on the media guide] to cut media at the base lines on the media guides.
4. Press [Cut].
• Start cutting at the cut position that you set.
• When [Base line position on the media guide] is selected, media is fed to the media cutter
position before starting cutting.
5. Press [Set].
• When automatically cutting printed media, the settings in RIP software are required. For details, see
"Changing Printer Settings", RIP Settings Guide.
2. Basic Operations
104
To Next Page
Loading...
