Connecting the Cable
This section explains how to connect an Ethernet interface cable and power cord.
Connecting to the Ethernet Interface
This section describes how to connect an Ethernet interface cable to the Ethernet port.
If you use an Ethernet interface cable that supports 1000BASE-T, set [Ethernet Speed] to [Auto
selection] in [Network Settings] on the [Initial Setting] screen.
• If the main power switch is on, turn it off.
1. Make sure the main power switch is turned off.
2. Connect the Ethernet interface cable to the Ethernet port.
3. Connect the other end of the Ethernet interface cable to a network connection device such
as a hub.
4. Turn on the main power switch of the machine.
1. Indicator (orange)
When 100BASE-TX is operating, the LED is lit orange.
1. Getting Started
28
To Next Page
Loading...
