When set to [All On], you can change the temperature in increments of 5°C within a 20 to 70°C
or 20 to 95°C range by pressing [ All +5°C] or [ All -5°C].
(mainly North America)
When set to [All On], you can change the temperature in increments of 9°F within a 68 to 158°F
or 68 to 203°F range by pressing [ All +9°F] or [ All -9°F].
Cure
Specify whether to enable the cure heater. When selecting the [On] check box, the heater is
enabled, ink can be fixed and cured after printing.
Default: [Disable]
(mainly Europe and Asia)
Default: [70°C]
When you select the [On] check box, the temperature can be set from 20 to 95°C, using [ ] or
[ ].
(mainly North America)
Default: [158°F]
When you select the [On] check box, the temperature can be set from 68 to 203°F, using [ ] or
[ ].
[Origin Setting] Screen
This section explains the setting items and default values on the [Origin Setting] screen.
Print-start position
Specify the print-start position in the feeding direction.
• Rewind
• Feed
Specify the print-start position in the printing direction.
• Left
• Right
(mainly Europe and Asia)
Default: [0 mm]
(mainly North America)
Default: [0 inch]
Cut
Select where to cut media, and then cut it.
• Position of the cutter
List of Setting Items
151
To Next Page
Loading...
