(If the ink combinations are 4C+W)
1. Press the [Standard Procedure] key.
2. Press [Selected Setting for Head Alignment].
3. Press [Media Feed Correction].
4. Press [Level Setting].
5. Select the print layer to change the media feed correction level to [4 color], [white], [4
color -> white], [white -> 4 color], or [4 color -> white -> 4 color].
6. Select the print mode to change the media feed correction level to [6 Pass], [8 Pass], [12
Pass], [16 Pass], or [32 Pass].
7. Select the media feed correction level from [Level 0], [Level 1], [Level 2], and [Level 3].
8. Press [Close] 5 times.
9. Press [End].
The connection method for the print heads will be applied to the first printing job after these settings
are configured.
3. Convenient Usage
112
To Next Page
Loading...
