• Do not set media on the outside of the left and right media guides. If media is skewed, this may
cause the media to rise and the print heads to be damaged.
• When the edges of roll media are not aligned with the roll core, make sure to align them before
setting media. Failure to do so may cause the edges of roll media to bend or wrinkle.
• Before loading the roll media, open the center cover at the machine's front part, and then move the
media guides to the ends.
1. Grab the handle on the back of the machine to pull out the roll feed unit.
2. Temporarily place set media on the media support.
Place the media in the direction indicated in the following illustration.
When using media whose printing surface is rolled up on the outside
Setting Media
53
To Next Page
Loading...
