If the media's slack is uneven, return to Step 11 and try loading the media again.
24. Insert an empty roll core onto the roll core holder on the right side of the front of the
machine.
Insert the roll core as far as possible so that it does not move.
25. Release the roll core holder's holding lever on the left side of the front of the machine.
If necessary, move the roll core holder to match the width of the empty roll core.
26. Move the roll core holder to the right to insert it into the empty roll core.
Insert the roll core as far as possible so that it does not move.
Setting Media
61
To Next Page
Loading...
