5. Return the pre-heater cover to its original position.
• After returning the pre-heater cover to its original position, press its ends to make sure that it is
not bulging.
• If you operate the device with a bulge in the pre-heater cover, the cover may come open
during operation or printing.
6. Open the center cover on the front of the machine.
7. While holding down the center of the media, raise the media holding lever (front).
The pinch rollers rise and the media is unfixed.
8. While holding down the center of the media, pull the media straight out to the media
output location.
• Check that the media has been pulled out evenly.
• Use the scale on the post-heater to check the position of the right edge of the media.
9. Move the right-side media guide until it makes contact with the right edge of the platen.
10. Move the right edge of the media towards the left edge of the media guide.
Check that the right edge of the media and the left edge of the media guide are parallel relative to
the feed direction. If they are not parallel, media skewing or jamming may occur.
Setting Media
75
To Next Page
Loading...
