Printing with a Macintosh
This section explains how to load paper in the paper tray and print on it.
• You cannot load thick paper or envelopes in Tray 2 or 3.
• Curled paper may jam. Straighten any curls within 2 mm (0.08 inches) before loading.
• Load paper with the print side face down in the Tray 1-3.
• Load paper with the print side face up in the bypass tray.
• Printing on envelopes
• Before loading envelopes, make sure their edges are sharply creased by rubbing the edges
with a pen or similar object.
• Load envelopes with their flaps closed.
• If you print on glossy paper, be sure to remove each sheet as it is delivered to the output ramp.
1. Load paper into paper tray.
How to load paper depends on the paper type. See page 86 "Loadable Paper Sizes and
Quantities".
2. Open the Print pane.
See page 185 "Displaying the Print Pane on a Macintosh".
3. If necessary, select the paper tray from the [Paper Feed] settings.
4. Specify the color mode and printing mode from the [Setup] settings.
If you select [Inkjet Plain Paper], the machine will print on one side only. To print on both sides,
select [Plain].
Printing with a Macintosh
187
To Next Page
Loading...
Need help?
General