USB Setting
You can specify the settings related to communication when the computer and machine are
connected via USB. Usually, you do not need to change these settings.
After changing this setting, turn the machine off, and then turn it on again.
USB Speed
Default: [Auto]
Port Setting
Default: [Off]
Changing the [Host Interface] Menu
This section gives an example of changing a setting in the [Host Interface] menu.
1. Press the [ /Menu] key.
2. Press the [ ] or [ /Menu] key to display [Host Interface], and then press the [#Enter]
key.
Menu:
Host Interface
3. Press the [ ] or [ /Menu] key to display [I/O Timeout], and then press the [#Enter] key.
Host Interface:
I/O Timeout
4. Press the [ ] or [ /Menu] key to display [20 seconds], and then press the [#Enter] key.
I/O Timeout:
20 seconds
5. Press the [Escape] key.
Precautions to Take When Using in a Network
Using DHCP
• You can register the host name to a DNS server. In the Web Image Monitor menu, you can
enable or disable [Notify Host Name to DHCP Server]. For details, see page 165 "Changing
the Machine Settings".
• The DHCP Relay Agent is not supported.
• Supported DHCP server operating systems are: Windows Server 2003/2003 R2, Windows
Server 2008, and UNIX standard.
4. Machine Setup Menus
152
To Next Page
Loading...
Need help?
General