Remove Misfeed Open Top Cover / Press Form Feed, remove misfeed
A paper jam occurs.
Open the top cover, press the [Form Feed] key, and then remove the jammed paper from the opening.
See page 229 "Removing Paper Jammed under the Top Cover"
Reset Bypass Tray correctly
The bypass tray has not been installed correctly.
Reset the bypass tray correctly.
See page 30 "Attaching and Detaching the Multi Bypass Tray", page 254 "No Paper/Tray Not
Detected (Bypass Tray)".
Reset Duplex Unit correctly
The duplex unit is not attached correctly or its cover is open.
Make sure the duplex unit is attached correctly and its cover is closed.
See page 28 "Attaching and Detaching the Duplex Unit", page 256 "Cover Open".
Resetting Job...
The machine is reinitializing a print job.
Wait a moment.
Right Front Cover is open / Close Right Front Cover
The right front cover is open.
Close the print cartridge cover.
See page 258 "Cover Open / Print Cartridge(s) Not Detected".
Right Int. Unit almost full
Internal unit is a service replacement part.
For details about internal unit replacement, contact your sales or service representative.
SCXXX-XX Power Off On / Call Service if error reoccurs
An error has occurred.
Turn the machine off and then on. If the message reappears, contact your sales or service representative.
Setting change…
The machine is updating the network interface.
Wait a moment.
Temp. alert Please wait...
The machine is too hot or cold at start-up.
Wait until "Ready" appears on the display.
Error & Status Messages on the Display
251
To Next Page
Loading...
Need help?
General