The surface should be level within two degrees.
Make sure the power cord is not trapped under the machine.
3. Press the [Power] key.
The machine starts feeding ink into its print heads.
Leave the machine idle for about six minutes until the message "Ready" appears.
Do not remove the plug from the wall outlet while the ink is being fed.
You might hear a clicking sound while the print heads are being filled. This is not a malfunction and
it will stop after a while.
When ink is completely fed, the [Power] key stops flashing and remains lit.
Plugging in the Power Cord and Turning the Power On
49
To Next Page
Loading...
