Ridder RW800 - Table of Contents

TABLE OF CONTENTS
1. GUIDELINES, STANDARDS AND CONDITIONS
1.1 Applicable guidelines and standards 3
1.2 Approved personnel 3
1.3 Warning about discouraged use 3
1.4 Warranty provisions 3
2. SAFETY, PRECAUTIONS AND SYMBOLS
2.1 Signal words, instrucons and warnings 4
2.2 Precauons and safety instrucons 5
2.3 Residual risks 6
2.4 Symbols and abbreviaons 7
3. PRODUCT DETAILS
3.1 Idencaon 8
3.2 Descripon 9
3.3 Applicaon 10
3.4 Dimensions 11
3.5 Technical specicaons 13
4. INSTALL INSTRUCTIONS
4.1 Special tools and equipment 15
4.2 Mounng posions 15
4.3 Sprockets 18
4.4 Installaon 19
4.5 Installaon opons A–F for output shas 23
4.5.1 Basic output shas (BOS) 23
4.5.2 Special output-shas (D, LD, LK ....) 23
4.5.3 Installaon chain (for A–D) 24
4.6 TRA drive-unit onto RW45\240TRA motor gearbox 25
4.7 Belt drum onto RW45\240/400L motor gearbox 27
4.8 Cable drum onto RW45\240/400L motor gearbox 28
5. CONNECT INSTRUCTIONS
5.1 Removal covers 29
5.2 Electrical material 30
5.3 Protecon - Condions and starng points 32
5.4 Tightening-torque motor-connecons 33
5.5 Control-circuit connecon - 3-wire [RLS] 34
5.6 Motor-current connecon - 3-wire [RLS] 35
5.7 Control-circuit connecon - 5-wire [RSU] 36
5.8 Control-circuit connecon - 5-wire, Alternave [RSU] 37
5.9 Change Direcon-of-rotaon - Switching sense 38
5.10 OPTIONAL - Posion Feedback 38
6. USER INSTRUCTIONS
6.1 Usage - Condions and starng points 38
6.2 Direcon-of-rotaon RW motor-gearboxes 40
6.3 Operaon 42
6.4 Safety funcons and stop funcons 42
7. COMMISSIONING INSTRUCTIONS
7.1 Commissioning - Condions and starng points 42
7.2 RLS/RSU limit-switch system 43
7.3 Adjusng the end posions 45
7.4 Installaon covers 46
8. MAINTENANCE INSTRUCTIONS
8.1 Maintenance 47
9. SERVICE
9.1 Troubleshoong 48
9.2 Technical support 49
10. ENVIRONMENT
10.1 Decommissioning and removal 49
10.2 Waste disposal 50
Ridder Drive Systems B.V.
T +31 (0)341 416 854 - F +31 (0)341 416 611 - I ridder.com
2