Ridder RW800 - Product Details; Identification

3. PRODUCT DETAILS
3.1 Idencaon
This product manual is only applicable to:
• Ridder Motor Gearboxes RW 1-phase
• Serial numbers from 200.900.000
• Item numbers from 500000.
Idencaon is possible from the scker on the locaon shown. Refer to the explanaon that
follows on how to read the informaon. For more informaon on item numbers and models refer to
the Ridder catalog or website at ridder.com.
EXAMPLE
Ê
Ê
COVERS
= If not applicable: No symbol in idencaon.
NOTE: Possibly the sequence of symbols is dierent and/or other symbols are included in the idencaon. Not all symbols
and assembled conguraons (such as LK, LD, ...) are included in the explanaon.
* K = Sprocket in an assembled conguraon.
WI: White color nish
z16: Oponal sprockets
Alternaves: z12/3z16 (3x for D model)
IP55: Protecon rang
No symbol in idencaon = IP54
Alternaves: 11/18/22/25/30/37/44/55/66/110/130
1: 1-phase mains voltage
115: Mains voltage [V]
09: Motor power at 50\60 Hz [daW]
86: Limit-switch range motor-gearbox
L: Model with winch sha
45 = Torque 120, 90 or 60 Nm
Alternaves: 70/140/400/600/800
RW: General designaon Ridder RW motor-gearboxes
CU: CSA/UL cercaon mark
Alternaves: 3C (CCC)/C (CSA)/U (UL)
Alternaves: 55/97/120/860
60: Mains frequency [Hz]
No symbol in idencaon = 50 Hz
Alternaves: 230
TRA: Model for built-on rack unit
D: Model with connuous worm-sha
No symbol in idencaon = Sprockets (K)*
1: Rotaonal speed of drive sha at 50(60) Hz [rpm]
Alternaves: 2/3/5/34(41)
240: Torque [Nm]
P: Thermal-Overload Protecon-Switch (PTO)
V: Grease lubricaon
No symbol in idencaon = Oil lubricaon
Ridder Drive Systems B.V.
T +31 (0)341 416 854 - F +31 (0)341 416 611 - I ridder.com
8