ROBOTIQ HAND-E - Applied Standards

Robotiq Hand-E Gripper - Instruction Manual
12.2. Applied standards
This section describes all applied harmonized standards for the design and production of the Robotiq Hand-E Gripper. Standards are
applied were applicable, some points may not be applied if not applicable to this specific product. Conformity is not enforced by any
laws, it is self-applied and the aim is to define normal safety and performance requirements for similar products.
Caution
Conformity of the product is only met if all instructions of this manual are followed. Among others: installation, safety
measures and normal usage must be met.
The following standards have been applied:
NF EN ISO 12100
2010Safety of machinery — General principles for design — Risk assessment and risk
reduction
CEI 60204-1 Ed6.0 2016Safety of machinery — Electrical equipment of machines — Part 1: General requirements
NF EN ISO 14539
2000Manipulating industrial robots — Object handling with grasp-type grippers —
Vocabulary and presentation of characteristics
NF EN ISO 9409-1 2004 2004Manipulating industrial robots — Mechanical interfaces — Part 1: Plates
90