Roche Cedex Bio System User Manual

Roche Diagnostics
Operator’s Manual · Version 3.1 B-107
Cedex Bio System 6 Special operations
Exporting data
cal_yyyymmddhhmmss.csv
Column Title Description
Instr Instrument ID (always 30 for Cedex Bio)
Msg Message Type:
7 Result for sample, control, or calibration
Index 151 Calibration data
152 Std-1 value
153 Std-2 value
154 Std-3 value
155 Std-4 value
156 Std-5 value
157 Std-6 value
App Application code
Date Date when the result was generated
Time Time when the result was calculated
SW-Version Software version installed on the instrument
Serial Serial number of the instrument
Cal/Std Calibrator ID (C.f.a.s. = 401) and standard number
User User name ($SYS$ if Auto Accept is on)
Lot Lot number
LS/Value Calibration type/Target value of corresponding calibrator
L Lot calibration
S Set calibration
Unit Defined display unit
Flags Flag name
R0/Rate Offset and factor of the calibration curve
Kc/Raw01 Kc parameter value or absorbance value of cycle 1 in Abs.
A/Raw02 A parameter value or absorbance value of cycle 2 in Abs.
B/Raw03 B parameter value or absorbance value of cycle 3 in Abs.
C/Raw04 C parameter value or absorbance value of cycle 4 in Abs.
Raw05 - Raw40 Absorbance value of cycle 5 through 40 in Abs. (one cycle = 18 s)
Test Short name of the application
Table 34 Explanations on calibration results
If the calibration results were accepted using Use Old, "???" is displayed as the Date and
Time values, and the corresponding values for Raw1 - Raw40 are missing.

Roche Cedex Bio System Specifications

General

Brand	Roche
Model	Cedex Bio System
Category	Measuring Instruments
Language	English