Roche Cedex Bio System User Manual

Roche Diagnostics
Operator’s Manual · Version 3.1 E-31
Cedex Bio System 13 ISE operation
Replacing ISE fluid bottles
5 Press .
A screen is displayed, asking you to scan the bottle barcode or to type it manually.
6 Scan the bottle barcode.
7 Press .
8 Observe the messages on screen and react accordingly.
If the barcode cannot be read, type it manually.
When the scanning process is finished, a message is displayed, asking you to
replace the bottle.
9 Open the ISE cover.
10 Remove the tubing adapter by lifting it and placing it on a clean lint-free tissue.
11 Remove the bottle.
12 Remove the cap of the new bottle.
13 Place the new bottle.
14 Insert the tubing adapter.
15 Close the ISE cover.
16 On the screen, press to confirm the placement.
The system performs the Prime ISE Reference and Calib. maintenance action.
17 Press to close the screen for reading barcodes.
Allow at least 15 seconds for priming the ISE bottle before continuing with any
other activity.
18 On the ISE status screen, press .
A placement list is displayed, telling you where to place ISE Solution 1 and 2.
19 Place ISE Solution 1 and ISE Solution 2 on the positions indicated on the screen.
20 Press .
The Overview tab is displayed.
21 Press to perform the main calibration.
22 When the system is in Standby status, remove ISE Solution 1, and ISE Solution 2
from the sample area.
23 Press .
Make sure to place a full bottle.
You need to perform a main calibration before you can process orders.

Roche Cedex Bio System Specifications

General

Brand	Roche
Model	Cedex Bio System
Category	Measuring Instruments
Language	English