Rockwell Automation Publication 2080-QS004C-EN-E - October 2023 93
Chapter 18
Configure PanelView 800 Terminal Ethernet Settings
1. On the PanelView 800 terminal main configuration screen, select Terminal Setting > Communication.
2. If the IP Mode is “DHCP”, select Disable DHCP.
3. Select Set Static IP Address.
4. Set IP Address as 192.168.1.2.
5. Set Mask as 255.255.255.0.
6. Leave the Gateway as default 0.0.0.0.
7. Select Back to go back to the Communication screen.
8. Select Main to go back to the main configuration screen.
To Next Page
Loading...
