Rockwell Automation Allen-Bradley LiquiFlo 2.0 - Page 117

Rockwell Automation Publication D2-3518-4 - January 2020 117
Parameter Descriptions Chapter 9
Figure 46 - Drive Status 2 (210)
Indicates Type 1 alarm conditions that currently exist in the drive. Note that for
alarm conditions not configured in Alarm Config 1 (259), the status indicated is
a zero.
See Chapter 10
for more information about alarms.
Figure 47 - Drive Alarm 1 (211)
Bit 0 - Ready = No start inhibits are active.
Bit 1 - Active = Drive is generating output voltage to the motor.
Bit 2 - Running = Drive is generating output voltage to the motor,
run has been selected.
Bit 8 - AutoRst Ctdn = Auto Restart Countdown. See parameter 174.
Bit 9 - AutoRst Ac = Auto Restart Active. See parameter 174.
Bit 11 - Bus Freq Reg = Drive is regulating bus frequency.
211
Drive Alarm 1
Range: See Figure 47
Default: Read Only
Access: 1 Path: Utility > Diagnostics
Utility > Alarms
See also: 212, 259
0110000x011101xx
0011234567891112131415
1 =Condition True
0=Condition False
x =Reserved
Bit #
Ready
Active
Running
Jogging
Stopping
DC Braking
AutoTuning
AutoRst Ctdn
AutoRst Act
Curr Limit
Bus Freq Reg
Motor Overld
DPI at 500 k
Nibble 1Nibble 2Nibble 3Nibble 4
000000x000
000
xxx
0011234567891112131415
1 =Alarm Active
0=Alarm Inactive
x =Reserved
Bit #
Prechrg Actv
UnderVoltage
Power Loss
Str At PwrUp
Anlg in Loss
IntDBRes OH
Drv OL Lvl 1
Drv OL LVl 2
Decel Inhibit
Waking
Not Synced
Phased ACB
Nibble 1Nibble 2Nibble 3Nibble 4