74 Rockwell Automation Publication D2-3518-4 - January 2020
Chapter 9 Parameter Descriptions
The Main Control board software version.
Frame 3 drives (firmware version 1.x) only:
The lower byte of this parameter controls the state of the application digital
outputs on the AC Line I/O card. The upper byte controls the operation of the
rectifier when configured for manual operation.
See AC Line I/O Board Description (Frame 3 Only)
on page 25 through
Combined I/O Board Description (Frame 4 Only)
on page 29 for a description
of I/O hardware that is present on this drive and is controlled by the inverter.
Figure 30 - Appl Digital Output (30) Frame 3
Frame 4 drives (firmware version 2.x) only:
The lower byte of this parameter controls the state of the shunt trip digital output
and the six application controlled digital outputs on the Combined I/O board.
The upper byte controls the operation of the rectifier when configured for
manual operation.
30
Appl Digital Out
Range: See Figure 30 and Figure 31
Default: See Figure 30 and Figure 31
Access: 1 Path: Monitor > Application
See also:
000000xx00xxxxxx
0011234567891112131415
1 =Active
0=Inactive
x =Reserved
Bit #
Factory Default Bit Values
AC Line I/O Dig. Output 1
AC Line I/O Dig. Output 2
AC Line I/O Dig. Output 3
AC Line I/O Dig. Output 4
AC Line I/O Dig. Output 5
AC Line I/O Dig. Output 6
Close Pre-charge
Enable Rectifier
Nibble 1Nibble 2Nibble 3Nibble 4
To Next Page
Loading...
