Getting Started
R&S
®
CMW500
44User Manual 1173.9463.02 ─ 02
Press the "MEASURE" key to open the Measurement Controller Dialog, from where you
can select each of the measurement applications which are enabled on your instrument.
Press the "SIGNAL GEN" key to open the Generator/Signaling Controller Dialog and
activate a generator or signaling application.
Press the TASKS key to display the previously selected measurement, generator, and
signaling applications across the bottom of the screen.
Press one of the hotkeys to open the main dialog of the associated firmware application.
See also chapter 3.1.5, "Configuring the Task Bar", on page 47.
Within a measurement application, press the "Config" hotkey in the lower right corner of
the screen to open the configuration dialog for the measurement.
Basic Tasks
To Next Page
Loading...
