Rohde & Schwarz FSWP Series - Page 44

Configuration
R&S
®
FSWP
44User Manual 1177.5856.02 ─ 07
5.3.1.4 Probes
Access: "Overview" > "Input" > "Probes"
The functionality to use probes (via the RF input) is the same as in the optional spec-
trum application.
For a comprehensive description, refer to the user manual of the optional R&S FSWP
spectrum application.
5.3.1.5 External Mixers
Access: "Overview" > "Input" > "Input Source" > "External Mixer"
Input through external mixers is available with the optional external mixer control hard-
ware.
The features are the same as in the phase noise application. For a comprehensive
description, refer to the R&S FSWP user manual.
5.3.1.6 Settings for Input from I/Q Data Files
Access: "Overview" > "Input/Frontend" > "Input Source" > "I/Q File"
Or: [INPUT/OUTPUT] > "Input Source Config" > "Input Source" > "I/Q File"
For details, see Chapter 4.2, "Basics on Input from I/Q Data Files", on page 25.
I/Q Input File State........................................................................................................ 44
Select I/Q data file ........................................................................................................45
File Repetitions............................................................................................................. 45
I/Q Input File State
Enables input from the selected I/Q input file.
If enabled, the application performs measurements on the data from this file. Thus,
most measurement settings related to data acquisition (attenuation, center frequency,
measurement bandwidth, sample rate) cannot be changed. The measurement time
can only be decreased, to perform measurements on an extract of the available data
only.
Configuring Data Inputs and Outputs