R&S ZVL Command Reference
Instrument-Control Commands
Operating Manual 1303.6580.32-05
365
CALCulate<Chn>:LIMit:LOWer:SHIFt <offset>
Shifts all lower and upper limit line segments assigned to the active trace in vertical direction.
This command is identical with CALCulate<Chn>:LIMit:UPPer:SHIFt.
<Chn>
Channel number used to identify the active trace.
<offset>
Response offset value for all limit line segments.
Range [def. unit] Almost no restriction for limit segments; see Rules for Limit Line Definition.
[dB]
*RST value –
SCPI, Command
Types
Device-specific, no query.
Example:
See CALCulate<Chn>:LIMit:LOWer:FEED.
CALCulate<Chn>:LIMit:LOWer:STATe <Boolean>
Switches the lower limit check on or off. Lower limit line segments are assigned even numbers; see
CALCulate<Chn>:LIMit:LOWer[:DATA]. The command does not affect segments with odd numbers.
Use CALCulate<Chn>:LIMit:STATe to switch on or off the entire limit check, including upper and
lower limit lines.
<Chn>
Channel number used to identify the active trace.
<Boolean>
ON | OFF - Limit check on or off.
*RST value OFF
SCPI, Command Types
Confirmed, command or query.
Example:
CALC:LIM:LOW -10, 0, 0, -10
Define the following lower and (default) upper limit line segments:
CALC:LIM:LOW:STAT ON; CALC:LIM:FAIL?
Switch the limit check on and query the result.
CALCulate<Chn>:LIMit:RDOMain:COMPlex S | SINV | Y | Z | YREL | ZREL
Deletes the existing limit line and (re-)defines the physical units of the response values of the limit line.
The units of the stimulus values are defined via CALCulate<Chn>:LIMit:CONTrol:DOMain.
This command is complemented by CALCulate<Chn>:LIMit:RDOMain:FORMat and
CALCulate<Chn>:LIMit:RDOMain:SPACing.
<Chn>
Channel number used to identify the active trace.
To Next Page
Loading...
