Rohde & Schwarz ZVL series - Page 381

R&S ZVL Command Reference
Instrument-Control Commands
Operating Manual 1303.6580.32-05
366
Parameters
K
e
yword for the physical unit of the response values.
Range [def. unit] The parameters form four groups:
 S and SINV select relative units (dB) for the limit line.
 Y selects admittance units (S/Siemens).
 Z s
elects impedance units (V).
 YREL and ZREL select dimensionless numbers (U).
[–]
*RST value –
SCPI, Command Types
Device-specific, no query.
CALCulate<Chn>:LIMit:RDOMain:FORMat COMPlex | MAGNitude | PHASe | REAL |
IMAGinary | SWR | GDELay | L | C
Deletes the existing limit line and (re-)defines the physical units of the response values of the limit line.
The units of the stimulus values are defined via CALCulate<Chn>:LIMit:CONTrol:DOMain.
This command is complemented by CALCulate<Chn>:LIMit:RDOMain:COMPlex and
CALCulate<Chn>:LIMit:RDOMain:SPACing.
<Chn>
Channel number used to identify the active trace.
Parameters
Keyword for the physical unit of the response values.
Range [def. unit] The parameters form four groups:
 COMPlex, REAL, IMAGinary, and SWR select dimensionless
numbers (U) for the limit line.
 MAGNitude selects relative units (dB).
 PHASe selects phase units (deg).
 GDELay selects time units (s).
 L selects inductance units (H/Henry).
 C selects capacitance units (F/Farad).
[–]
*RST value –
SCPI, Command
Types
Device-specific, no query.
CALCulate<Chn>:LIMit:RDOMain:SPACing LINear | LOGarithmic | dB | SIC
Deletes the existing limit line and (re-)defines the physical units of the response values of the limit line.
The units of the stimulus values are defined via CALCulate<Chn>:LIMit:CONTrol:DOMain.
This command is complemented by CALCulate<Chn>:LIMit:RDOMain:COMPlex and
CALCulate<Chn>:LIMit:RDOMain:FORMat.
<Chn>
Channel number used to identify the active trace.