Rohde & Schwarz ZVL series - Page 395

R&S ZVL Command Reference
Instrument-Control Commands
Operating Manual 1303.6580.32-05
380
Suppose that the active setup contains an active trace no. 1.
CALC:MARK ON
Create marker 1 and assign it to trace no. 1.
CALC:MARK:FUNC:EXEC MAX; RES?
Move the created marker to the absolute maximum of the trace and query the
stimulus and response value of the search result.
The analyzer provides the following search modes:
Mode Find...
MAXimum
Absolute maximum in the search range (see CALCulate<Chn>:MARKer<Mk>:FUNCtion:DOMain:USER
<numeric_value>)
MINimum
Absolute maximum in the search range
RPEak
Next valid peak to the right of the current marker position
LPEak
Next valid peak to the left
NPEak
Next highest or lowest value among the valid peaks (next peak)
TARGet
Target value (see CALCulate<Chn>:MARKer<Mk>:TAR
get)
RTARget
Next target value to the right of the current marker position
LTARget
Next target value to the left
BFILter
Bandfilter search. The results are queried using CALCulate<Chn>:MARKer<Mk>:BWIDth.
CALCulate<Chn>:MARKer<Mk>:FUNCtion:RESult?
Returns the result (stimulus and response value) of a search started by means of
CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute. The search must be executed before the
command is enabled.
<Chn>
Channel number used to identify the active trace.
<Mk>
Marker number in the range 1 to 10. This numeric suffix is ignored and may be set
to any value.
Response
Search result in the format <Stimulus value>, <Response_value>.
Range [def.
unit]
Depending on the measurement parameter. [unit depending on the sweep type and
the marker format; see CALCulate<Chn>:MARKer<Mk>:FORMat]
*RST value –
SCPI,
Command
Types
Device-specific, query only.
Example:
See CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute.
CALCulate<Chn>:MARKer<Mk>:FUNCtion[:SELect] MAXimum | MINimum | RPEak
| LPEak | NPEak | TARGet | LTARget | RTARget | BFILter
Selects a search mode for marker no. <Mk>, which can then be initiated using one of the
CALCulate<Chn>:MARKer<Mk>:SEARch..., CALCulate<Chn>:MARKer<Mk>:MAXimum or
CALCulate<Chn>:MARKer<Mk>:MINimum functions. The marker must be created before using
CALCulate<Chn>:MARKer<Mk>[:STATe] ON.